Saturday 14 October 2017

Push Bike Engine - YG TRAKTOR





www.pushbikeengine.ie - Bikes with style



Custom bike, 80cc engine. 7 gears. front & rear disc brakes. Double brake lever. Camshaft transmission. US top quality freewheel.  26 inches fat wheels.


Saturday 23 September 2017

Full Pedal Assistant Start-Stop Eco Friendly System “ CELTIC ”.

Wednesday 14 June 2017

Rear wheel is blocked !!!

This happens if the chain is to loosed . Be careful because some time during riding  if that happen you may fall of the bike . Its dangerous!!! Keep tight the chain ,  To unblock the chain use big  flat screwdriver and release the chain from the sprocket then tight the chain idler. In some cases if the clutch is to loosed can make same effect! Follow our instructions how to use properly the bike. Please subscribe to our YouTube channel.
 Subscribe here

Thursday 3 November 2016

How to improve the kill-switch


Here we can show you how you can improve your kill-switch, in most cases the throttle grip wear out and often have to be  replace with new. So, in this case you can use your throttle grip for long. See the pictures bellow.  




Sunday 10 July 2016

The chain touches the camshaft cover

Here in this post you can see another tricky way how you can stop a noise from the camshaft cover. See the picture , originally there is with right base, you have to use grander and to sanding the part like a curve . This is very important part of installation and you can safe future issues.


Saturday 9 July 2016

How to connect electric cables


There is some useful information about electric system. This information missing in the  manual book
You have to connect blue cable with blue and the yellow cable from kill switch have to be connect with blue cables. Black with black and green cable from kill switch have  to be connect with black cables. The white cable is for lights, but my recommend is don't use it, just insulate it.  If the wires be exchanged you will broke all electric system, this including kill switch, CDI -Ignition & magneto coil. This does not happen immediately, but after few minutes maybe half hour the engine just stop. Its very important how will connect the cables.



Friday 8 July 2016

How to clean & prepare magneto coil

In this post will show you how to clean magneto coil of new or used engine. In most cases the metal is coated with lacquer and connection is bad. Take piece of sandpaper and just cleаn  surfaces. / see the picture below/ then insert the screws and make adjustment. Its easy way to do it and will save you hassles in the future.

                         

Regards